A collection of case histories of successful collaborations between High Technology Network Laboratories and businesses. These are tangible and customisable examples of the application of new technologies, products, or services that show how industrial research can meet the needs of innovation.
Additive manufacturing (AM) affords design freedom, topological optimization and ability to develop material/component combinations with “site-specific” properties. AM therefore is an effective tool to meet the growing needs of both high...
Liquefied Natural Gas (LNG) is a low environmental impact fuel capable of reducing considerably the emissions of sulfur oxides and nitrogen oxides, as required by the European regulation (directive 2012/33 / EU). The CLEANPORT project provided the...
Motion planning for robotic manipulators is usually considered a problem with well-settled solutions. However, also in this field, new applications, often non-standard, pose new challenges. Among them, the transporation/manipulation of liquid...
The choice of a light alloy for the production of mechanical components implies, also, the choice of the most suitable heat treatment. Even if heat treatment parameters are defined in the international standards, microstructure, induced in the alloys...
Many machines have a noise emission largest of 80 dB (A) at the workplace and therefore carry a risk of moise exposure for workers; the demands of the market are to be more and more towards a noise level less than this threshold, thus the...
Engineering components, in relative motion under load, dissipate energy due to friction and and suffer surface damage due to wear. In order to limit these phenomena, a new discipline called “tribology” has been developed. The importance of a...
In the field of automatic machines and Robots with high dynamics the need for velocities higher and higher collides with the requirements of precision and reliability. This is mainly caused by the motion control systems that are not able to track...
The design of control systems can be based on commercial off-the-shelf devices, easily scalable and interoperable. The rapid growth of the functionalities, which characterize modern control systems, complicates the selection of the proper...
The assessment of product quality using objective techniques and the identification of defects or malfunctions during testing play an increasingly dominant role in enterprises. These objectives may often be pursued by studying the vibratory signal...
Especially over the last few years, the aspects connected to vibro-acoustic issues have been playing a key role within the design pathway of industrial products and machinery. In particular, following regulations that limit the emission of vibration...
Remote monitoring and control of automatic machines and systems is one of the most interesting ICT application sectors at industrial level. The i-Maintenance platform by CenTec allows monitoring and control, diagnostics and prognostics, configuration...
A casting component must be developed considering promptly the critical issues arising from the manufacturing process. Uninformed component design inevitably causes problems in the production stage, resulting in the need for deep geometric review...
Direct Laser Hardening (DLH) in numerical control machining centres is a process to superficially harden mechanical components at the end of removal processing and directly on the machining centre where they have been made, thus avoiding induction...
The development of customised test benches for R&D laboratories addresses the need by Businesses to reduce the time for new products' development and improvement of existing ones. To this end it is essential to have tools with a user-friendly...
The design decisions of many small and medium-sized companies that produce turbomachines in specific sectors are based more on experience than on an analytical approach. In fact, fluid dynamics simulation software often requires very costly licences...