A collection of case histories of successful collaborations between High Technology Network Laboratories and businesses. These are tangible and customisable examples of the application of new technologies, products, or services that show how industrial research can meet the needs of innovation.
An automatic system for laser marking was developed in cooperation with Robby Moto Engineering (RME), by adding a vision system to a LASIT commercial marker. The system is able to recognize the pieces inserted in the machine and autonomously complete...
The DIGIMAN project aims to develop tools to support the transformation of a generic industrial machinery into a Cyber-Physical System. This result will be possible thanks to the definition and implementation of a hardware-software platform, called...
Additive manufacturing (AM) affords design freedom, topological optimization and ability to develop material/component combinations with “site-specific” properties. AM therefore is an effective tool to meet the growing needs of both high...
Liquefied Natural Gas (LNG) is a low environmental impact fuel capable of reducing considerably the emissions of sulfur oxides and nitrogen oxides, as required by the European regulation (directive 2012/33 / EU). The CLEANPORT project provided the...
The evolution of machine tool industry is linked to the stakeholders’ need to constantly increase productivity, which means constantly improving the applied technologies. The research for increased sustainability, combined with the reduction of...
Motion planning for robotic manipulators is usually considered a problem with well-settled solutions. However, also in this field, new applications, often non-standard, pose new challenges. Among them, the transporation/manipulation of liquid...
The choice of a light alloy for the production of mechanical components implies, also, the choice of the most suitable heat treatment. Even if heat treatment parameters are defined in the international standards, microstructure, induced in the alloys...
Engineering components, in relative motion under load, dissipate energy due to friction and and suffer surface damage due to wear. In order to limit these phenomena, a new discipline called “tribology” has been developed. The importance of a...
Titanium alloys and Ni-based super-alloys are notoriously difficult to machine materials mainly because of their low thermal conductivity. This causes high cutting temperatures with a consequent triggering of a series of problems related to thermal...
In the field of automatic machines and Robots with high dynamics the need for velocities higher and higher collides with the requirements of precision and reliability. This is mainly caused by the motion control systems that are not able to track...
The design of control systems can be based on commercial off-the-shelf devices, easily scalable and interoperable. The rapid growth of the functionalities, which characterize modern control systems, complicates the selection of the proper...
A casting component must be developed considering promptly the critical issues arising from the manufacturing process. Uninformed component design inevitably causes problems in the production stage, resulting in the need for deep geometric review...
The experiences accumulated within the MUSP Laboratory in the field of redesig and, more broadly, design of structural parts of various types of machine tools, with conventional materials (especially electro-welded steel) and innovative ones such as...
Direct Laser Hardening (DLH) in numerical control machining centres is a process to superficially harden mechanical components at the end of removal processing and directly on the machining centre where they have been made, thus avoiding induction...
In the industrial realm it is now possible to have large amounts of data in various applications, from process monitoring to adaptive control. This “data rich” environment is mainly supported by two factors: the continuous development of high...